Phil I think I am going to try that. I wasnt going to take one inch off the control arm but figured I could at least take some of the flange away without affecting the strength of the arm. Thanks for giving me some hope I might squeek by. I was then going to mark the edge with some crayon and take the truck for a quick drive. I figured the crayon would show any contact. The wheels are DK-5 from DK wheels. I liked them on the truck before my lift and was hoping to retain them. Good advice from all though... 
__________________
2004 Lux with 6 inch Fabtech with tie rods, 38 inch MT's, 4:88 gears, and some minor engine tweaks.
|