Re: Vizualogic Problem
Checked mine and it comes on when you push the AUX DVD Power button on the remote. Monitors turn on by a separate monitor power button. After checking my system and the manual, I found no settings that can be changed for this feature.
If the system worked fine before I would try the following:
1. Change batteries in the remote.
2. Then try the DVD power from in front of the left monitor then the right
monitor. This way you can see if it is only one side causing the
problem.
3. If you have no luck you can remove the rear air vent/radio control panel from the center console, and unscrew and carefully lift out the the center console tray that the DVD is in. Be very careful doing this though because of the MANY RCA cables that might be pulled loose. Once you do this a few inches down on the cable that comes from the DVD you will see a thinner wire (smaller then the rest). This wire should have a jack like the ones you plug your headphones into on the top of an Ipod. This is the IR repeater wire. There should be another wire plugged into this jack. If not locate the male end and plug it in. If it looks plugged in, take it in and out a few times to make better contact (not being perverted), and try the remote again. If this doesn't work the DVD player IR receiver may have went bad causing the problem.
If you are good with wiring, Vizualogic will provide a schematic of the system for you, and there tech service is good and may be able to walk you through the troubleshooting.
Good luck.
|