[tower]

THE DRAWING BOARD
You need to run a jumper or diode from the parking lamp relay (test for a contact that becomes hot when the park lams switch is turned on) to the DRL relay (if you can find it) or to the fuse (see photo). Make sure that you go to the hot side of the fuse (the side which tests hot when the DRLs would normally be on). To find the DRL relay, you must listen for a click near the electrical panel when the conditions for the DRL change betweeen on and off (e.g. key in the on position, switch between PARK and DRIVE. Do this on level ground with wheels chocked if possible as setting parking break will lock DRL's on OFF condition. If you use a diode, place it so that current flows in the direction of the arrowheads on the drawn lines.