[H2Finally]

Tim,

If the clunk's from the entire HiLift rattling in its holder, I'd use some kind of rubber bushings. For mine, I drilled a hole through some round rubber door handle stop/wall saver off Home Depot. My HiLift is sandwiched between 2 of that, a big washer and wing nuts. Completely rattle free.

If the clunk's from the 2 parts of the HiLift, I'd use a velcro cord holder. Mine's wrapped around the handle twice and seemed to work really well.

Then again, my HiLift's way at the back on my rear tire carrier. But I never remember hearing any clunking.