Quote:
|
Originally Posted by wch
So, I took the trim off the A pillars. Found tape along the windshield edge but it was double-sided, which was interesting. I removed them both before I realized that the temp to put new double-sided 3M tape must be over 68 degrees. So I put them both back on without any tape.
Here's the kicker, the noise went away for the most part. THere is a little vibration but a hell of lot less than what existed before. Not sure I will put the tape back on. Thanks to everyone for the advice. Saved me from taking down the liner!
|
It'll come back... especially if you didn't use tape. When you do redo it, double up on the 3M two sided tape. Use two layers instead of one.
I've done mine 3-4 times... poor design.
Mark