Quote:
|
Originally Posted by Humdingah
I used the bed coating in a 'rattle can' for the bottoms of my QPP flares...did it to prevent any paint chips from rocks on the underside since they were painted all around. It's be over a year and it's held up fine...
Two or three cans should be more than enough to put a coat or two on all of the flares and in the event you need to recoat a section you could just buy another can and respray it. Much cheaper than Line-X and, as long as the flares are free of silicone and wax, the 'Line-X in a can' should have a decent surface to bond to.
Worth a try...
|
Does sound more cost effective, however I want a permanent fix for it and not one that there may be a "possibility" that I have to re-coat in a few months or even in a year. To totally encase the front, rear, and side trimmings, I was quoted at $980 if I bring the parts in and prep. However, after reading your response, I am considering spraying the belly of the beast, for mainly protection. Thanks again.......Jamie