Re: What are these for
yes I bought it new but Ive just now gotten around to makeing some improvements. I leveled it and added 35" toyo oc MT's, custom rubber floor mats and things like that. But I just bought a pair of piaa 520 ATP driving lights for the brush guard (my first pair ever) and after pondering the best way through the firewall I noticed the ones under the hood. Then I checked under the dash and found some more. they were taped better than that but I wanted to seperate them a little better for the pics.
So are these wires just wires that pass straight through and dead end on both sides? That would make wiring the switch about a millions times easier. Does anyone know for sure or know any way to test the wires to see if it the end under the hood is the same wire as the one under the dash???? I sure hope so, I was really not looking forward to drilling a hole in the firewall of my 3. And I am no electrical genious.
Also these lights have been sitting around for a while now, (no time to work on the things lately) and I seem to have lost the instructions. Theres two black leads and one white lead in the harness. Im assuming white is hot and connects at POS terminal, and the black one closest to it connects at NEG terminal. Now the other black lead Im not positive on. Im guessin you just ground it out? or do you also connect to NEG terminal? Any help would be great since piaa doesnt seem to have online instructions...and like I mentioned before, first timer here.
__________________
06 H3, Boulder Grey (somtimes/mostly just mud, color of mud varies), Leveling Kit, 35" Toyo Open Country M/T's, Westin chrome nerf bar, chrome brush guard, Chrome kit, chrome roof bars, navigation, XM,
brush gaurd lights. Want: 4" or 6" lift, rock rails to replace the steps, roof rack w/lights, want a rack above the spare on rear door, custom seat covers...should be done then but I doubt it 
|