Re: Question on mounting factory tail light guards
You can always sand the surface of the side where the screws would go in on the guards, and just get the 3M tape, and tape them anyway. I think it would work, and you can get the industrial strength 3M adhesive tape at almost an automotive parts place (Autozone or Checkers) I would do that over drilling holes any day. If it doesn't work, you can always just drill the holes. Besides, the 3M stuff is designed to stick on either plastic or metal, it's the stuff they use to stick ornaments and siding to the car, so I don't see why it wouldn't work on your tail light guards.
__________________
Sweet looking H2 with not enough mods (2003 Pewter H2, 20" Rockstars, 40"x15.5" Toyo MT's, E&G Extended Flares, Full body tube steel exoskeleton, 5" Skyjacker lift, Amp Research steps, Gobi Roofrack and ladders, Smoked LED's, AFe CAI, Dynatech long tubes and cats, Magnaflow exhaust, Stock tune, 4.88 gears, Chrome Grenade Shifter, interior blacked out, rear captains chairs, Solar Power!!)
|