[hotstang46`]

Now again refer to this picture and notice the back of the bulb on the new HID is alot longer than the stock bulb.




It will not fit in the new fog as it sits. So you need to cut a hole in the backplate of the fog the size of gromet that you see in the picture so that there's room for it protrude through.



I used a quarter and drew a circle on the backplates.......




I used a dremel to grind them out, it was a router style bit for metal, you can find them at any home depot. Don't worry about making the cut pretty and perfect, it's not needed.