[hotstang46`]

Next refer again to this picture and look at the V shaped mounts the fogs came with.



Cut them with a dremel and form a 90 degree bend. You will need to drill a hole in them for the mounting screws that will be holding them to the body of the truck. Take out the stock DRLS and you will see the two holes that the stock bolts ran through, measure the distance apart on those bolts, and with your newly made, undrilled tabs mark them at that distance when they are mounted on the fogs so you know where to Drill the holes. The holes that hold the brackets to the fog will already be there. wish i took a better pic but the holes that you see the screws that hold the bracket onto the foglight are slotted. they are like this as they are sent. this again is great because you can aim them when on the truck by loosening those screws and pulling one way or antother. when mounted on the truck you will be able to aim the fog up down left or right very easily to get the light where you want it.