Removing wiper arm is done by pulling up in the locking tab.
Attachment 51804
Pulling up locking tab.
Attachment 51805
Removing wiper arm, got to bend at a 90 degree, it helps.
Attachment 51806
Pulling off fake air intake.
Attachment 51800
Backside of fake air intake showing clips.
Attachment 51801
Fake air intake removed showing 1 of 2 screws to remove. (one will be under other side)
Attachment 51802
Passenger side of truck, just to the left of the windshield washer reservoir you can see 1 of the 2 push clips that needs removed, other will be on drivers side.
Attachment 51803
Got to pull up on the cowling to break loose the spring clips (4, I think) that hold it on just like the fake air intakes clips. Just take your time and you should be okay.
Attachment 51807
On the passenger side is where all the fluid lines come together.
Attachment 51808
Hope after all this you find the leak and can fix it and then reverse the whole process to put it back together. If you break one of the spring clips on the cowling, remove one from the fake air intake and use it to replace the broken one on the cowling. It is much easier to pull the fake air intakes to replace one of their clips. And just incase you do break one, just give me a holler, I bought a pack of them and would be glad to send ya what ya need clear over there in Sulzbach-Rosenberg, Germany
Good luck, Easy Ed