[Easy Ed]

Installed myself. Got to raise the frame up enough that the rear axle will hang high enough when supported by a floor jack to remove the two lower shock mounted and the two upper sway bar to frame mounts. Now lower the floor jack and there will be plenty of room to remove to air springs. Caution must be used here, if you cut the two air lines things tend to do weird sh!t, just be careful. The air spring has a anti rotation catch on top that when push down will allow you to turn the spring and remove it. The new coils come in a left and right spring with both needing to be "up". To me and the way I installed mine was that the drivers side of the truck is the LEFT side. Read some of the descriptions in the service manual to find out. The job for putting in the coils took about a hour.

The work of removing ALL compressor related parts, wires, sensors, plugs and even the ride height button took the rest of my weekend tracing wires was the hard part but I am so OCD that I wanted it all gone .

Attached ImagesRight and Left Spring with Isolator.jpg (76.8 KB, 278 views)Compressor Mounts 025.jpg (72.4 KB, 256 views)Compressor Mounts 026.jpg (85.3 KB, 237 views)
__________________