[finall]

Help Humtech!

I am going to disconnect this myself, instead of letting the dealer chop (yes, literally, they cut off the connectors and tape them) up on my Hummer.

How do you disconnect these connectors (labelled #1 and #2) ? Do you need a special tool? What do you do to get them apart (they are locked together)? I managed to pry the #2 apart, but the big #1 is a mystery.

How do you keep water off the wiring harness connector ends that stay in the vehicle? Normally when the 2 halfs are connected together, there is a water-tight seal in between. Now the exposed ends need to be wrapped in something very waterproof. I do not want to cut the connector off the end, in case some time in the future a retrofit can be done with a non-faulty heater of some sort.

I presume by disconnecting these, that the heated WW pump can't burn down the H2?