View Single Post
  #2  
Old 08-05-2010, 11:38 PM
Hellz Hellz is offline
Hummer Expert
 
Join Date: Mar 2009
Location: Burnsville, MN
Posts: 657
Hellz is on a distinguished road
Default Re: damn thats in there tight!

i had to call Fabtech about the install of these.

in the instructions, it shows that the zerk is up and spindle going down.
OEM is opposite. so fabtech told me " Nonlifted H2s go with OEM install.. Zerk down and spindle up" so if this helps anyone down the line.

also Fabtech calls for 35 ft lbs when torquing the spindle bolt in.
this seems pretty loose to me.
i ended up going with about 70 ft lbs.
i dont know how this will effect the tie rods in the long run, but i know they wont fall off.





Last edited by Hellz : 08-05-2010 at 11:54 PM.
Reply With Quote