UCAK100001
For the GM 01-06 8-Lug vehicles, including the 1500HD, 2500, 2500HD, 3500, and 2500 Suburban/YukonXL/Avalanche and Hummer H2
ya granted it lists the H2 on there, but all the vehicles listed are basically the same. the H2 does have a Yukon front end on it. there have been a few times already that i go to the parts store, and to be told they dont have a part for my H2, but when i tell them look up a Avalanche, they seem to magically have the part.
im pretty sure that the pulling is from the bearing hub, i just dont want to go through the effort of ripping it all the way down and putting it back together.
i think maybe the Hub maybe wasnt seated in 100% straight. maybe it is cockeyed (
) a little. i have been tossing the idea of picking up another hub to throw in there to replace this one all together and have the old one ( which is still new-ish about 1000 miles) as a trail backup or something.
since tighteniing down the UCA's, i have a feeling that maybe the shop will have a easier time getting an alignment on my H2. before, it would go close to OEM specs, and even closer to the Cognito specs, but there was no room on the guide on the drivers side. it was completely maxxed out.