[ehaser]

I took off the entire door panel both outer and inner. Then I lined the inside of the door (or opposite side of the exterior) with Dynamat.. Then I put everything back internally and then put one big sheet of dynamat over where that fabric crap is and then replace the plastic door panels. I have to say.. they did a horrendous job engineering the original door panels.. My doors are heavy as hell now and they shut with a thud! No rattles at all! If I could post pics I would but mine are all too large.

I'm currently having mine rebuilt from the ground up...and I mean from the ground up. We've disassembled the entire truck down to nuts and bolts currently. I'm having the frame dipped and coated.. It was all rusted and scaled like the previous owner had it sitting in a swamp. We're putting all new diffs in with 4.88's and drivlines. New upper cognito arms.. New wheels.. Aftermarket brake kit.. Etc..

The reason I'm going into detail here is this..

Just be careful...

The doors is where my rebuild started... LOL.

Once you dig in you'll want to re-engineer the entire truck!