Re: 17x10 wheel with at least 5" backspacing?
To see a comparison, including warnings of possible suspension and fender clearance issues, you can use this site (which is awesome):
http://www.rimsntires.com/specs.jsp
On the left side, where you enter the stock sizes as a base for comparison, you would use the stock 315/70, 17" diameter, 8.5" wide, and 18mm offset/ET (which yields a stock backspacing of 5.5"). On the right side, enter the specs for your new wheel/tire setup. Sadly, the tool doesn't support "high flotation" tire sizes where you use inch measurements for tire diameter and width, but you can at least get a sense for how different wheel setups will look and whether or not they will have clearance issues. Obviously, on the H2, we don't have to worry much about fender clearance, but it's wise to check the suspension clearance.
Good luck, let us know how it goes!
__________________
Mike
2000 HUMMER HMCS, kevlar flat black, Rubber Duck lift, Predator stage 3 kit, Predator (Wilwood) Big Brake kit, a work in progress...
2008 H2, graystone, air suspension (DELETED), U-steps, SMA brushguard w/valance (DRLs replaced by PIAA 520s), black taillight guards/locking fuel door/roof crossbars (x4), Cognito UCA/pitman-idler, Bilstein shocks, Rancho steering stabilizer, Kryptonite tie rods, green keys, Fuel D525 20" Revolver, 37" Nitto Ridge Grappler
|