[Hellz]

you can create a ground anywhere....

my recommendation is if you have your amp someplace in the back, either pull up the carpeting and sand off the paint in a small area about the size of a quarter, and use a self taping screw and use that as the ground.

otherwise, you can pull off the side panels and find a spot in there, and do the same thing. you might be able to use an existing bolt, but you will still need to sand it down to bare metal.

another option, you can run a ground cable from the engine compartment all the way to your amp. using the holes in the firewall, and pulling up the sill panels and routing under the carpet.


as for the fuse box.. there is the main fuse housing in the engin compartment right in front of the battery. pull the top off and you can access those fuses.

the other fuse box is inside the cabin.
open the drivers door, and on the side of the dash in where the fuse box is located. should have a recessed point where you can pull the panel off and access the fuses in there. on the cover that was pulled off should be a diagram of what fuses are where, and the rating for each.