Re: Lower Ball joint replacement?.....ED Help!!
Zerk fitting on old or new joint? For the old joint my cup on the press sat way over the zerk. On the first removal I did remove the zirk, but on the second I saw no need.
Zerk on the new joint I did not install until after the joint was pressed in. I did, and here's a nice little trick, chalk mark the zerk hole with the lower control arm so I could make sure it went in aligned up. Helped a ton. And on my first joint I did press in and back out due to zirk alignment.
__________________
_____________________________________
2006 HUMMER H2
MOOG Front End
Diablo InTune w/DiabLew Tune
Cognito Steering Support
OBX LT Headers
Air Raid Filter w/Tube
External Trans Cooler -Radiator Bypass
Corvette Servo
Rancho 9000 Adjustable Shocks-
Rancho Steering Stabilizer
20" Chrome Fuel Hostage - Cooper ST Maxx
Slotted Rotors/Ceramic pads/Steel Lines
Viper Smart Start
iPod/Video Interface
HID Head and Fog Lights
Optima Red Top w/ Priority Start Cut Off Mod
|