Re: Clunk when starting
Redline d4 in the TC.
After reading about the bushings under load it got me thinking.
This clunk, pretty sure, has only happened after the tranny brush guard has come off. I took it off to do the headers and it was off for the tranny flush.
I hadn't heard the clunk for a while until after the header install. I've read about clunks being caused by warped skid plates. My tranny brush guard is warped.
Not for sure but it does make sense at this point. Once it loosens up a bit after torquing it down the clunk goes away.
I'll continue to monitor and I'm also going to check all the bushings.
__________________
_____________________________________
2006 HUMMER H2
MOOG Front End
Diablo InTune w/DiabLew Tune
Cognito Steering Support
OBX LT Headers
Air Raid Filter w/Tube
External Trans Cooler -Radiator Bypass
Corvette Servo
Rancho 9000 Adjustable Shocks-
Rancho Steering Stabilizer
20" Chrome Fuel Hostage - Cooper ST Maxx
Slotted Rotors/Ceramic pads/Steel Lines
Viper Smart Start
iPod/Video Interface
HID Head and Fog Lights
Optima Red Top w/ Priority Start Cut Off Mod
|