I have the h2 parked in a place with no electricity, so I started removing the lower seat but didn't finish the job because night started to fall. I've got almost all the seat removed, I got the foam+seat disconnected from there, but I haven't removed the back end.
Here is where I'm at:
I can see the pins holding down the cover to the metal, but they are very strong. What do I need to do here, I presume I need to squeeze the head of the pins in order for them to pass through the holes, releasing everything? Because I tried a couple of times and they were very hard and didn't want to go through the holes. Lol.
I'll try to finish the job tomorrow, but this part was not being easy at all, and the light was fading out which wasn't helping.