Caution: Approved safety glasses and gloves should be worn when performing this procedure to reduce the chance of personal injury.
Notice: When servicing electrochromic glass that is broken, or if glass breaks during servicing, be cautious not to spill electrochromic fluid onto vehicle. Doing so will cause damage to the vehicle. 1. The top inboard corner is the ideal location for pulling the mirror out of the housing.
1. Remove the mirror face as follows:
2.1Push mirror glass bottom outboard (1) corner, furthest away from the vehicle door, as far as possible into the mirror housing.
2.2Place fingers tips behind the top inboard edge (2) corner, closest to the vehicle door.
2.3Pull the mirror glass with light pressure until the glass comes loose.
2.4Holding the mirror face, disconnect the electrical connectors from the back of the mirror.
Installation Procedure
1. Position the mirror face on a angle to the mirror housing.
1. Install the mirror face as follows:
2.1Holding the mirror face, connect the electrical connectors to the back of the mirror.
2.2Position the mirror face to the motor retainer tabs.
2.3Position the hand in the center of the mirror face.
2.4Apply light pressure to the face.
2.5Push downward and inward to lock in place.
2.6Inspect the mirror face for proper operation.