Quote:
|
Originally Posted by HUMTECH
Also wrapping module in latex is prob not a good idea, will still get some moisture in it due to heating up and cooling down creating condensation. With it wrapped up there is no where for the condensation to get out
|
Looks like its the ignition switch? Sprayed some WD 40 on the cylinder and then went over to a friend for scan. Of course when I got there everything worked fine! My master tech buddy scanned the computer and the BCM stored codes read power mismatch. After I left stopped for gas and shut the car off pulled out the key opened the door and got out and there it was again dash lit up and radio on. Put the key back in and wiggled it and power went off, so what do ya think?