Re: Tranny cooler installation
Alright, so how I installed mine, I straitened out the lower attach points, I then put a rubber grommet I cut between the bracket and the lower attach point, where I attached both bottom brackets, using a tek screw.
On the top I only attached the driver side, using just a tek screw.
I bent the passenger top toward the vehicle but haven't decided if I'm going to attach.
I honestly don't see how everyone is installing this cooler without it rubbing the condenser, by using just the top brackets.
I notice no difference in a/c
Driving medium hard through country roads for 12 miles I managed to get it up to 148 degrees (F) outside temp 89
|