Quote:
Originally Posted by LoJac963
No load resistors, I was surprised I wouldn't need either resistors or an LED flasher relay when I installed both the front and rear LEDs.
I have gone through the wiring like a mad man. Testing circuits, tracing wiring, etc to try and find the reason why they do that and I'm stumped. It is something to do with the board within the tail light. I've even tried jumping different contacts from the bulb sockets to the tail lights. Then I can get them to somewhat work correctly but all the functions arent' there. It is highly annoying.
|
Surprising that no resistors are needed. They must have them built in!
I would probably look at the bumper bulb and see if it had 3 different wires, and cut the turn signal wire. This way, it still comes on with the parking lights, but doesn't blink while turning. Im a bit anal though!