[jsbihn]

ok wait, i dont know if the high side is suppose to have a valve or not.
it almost looks like there is a ball pressed up in to a hole, and if you press the ball down it opens up the line.

(almost like a ball on a spring... ball seals the opening because it is pressed up into the port, push the ball down and it opens it and then you release and it closes)

I took a screw driver and pushed and when i did it did release pressure/ air/ freon....
so i am just checking to see if this is correct or if some how there is suppose to be a shraeder valve there and it was blown out


(btw, I can come to think that if this ball / springs setup is actually the way it is from the factory.... then basically by looking at it... it wouldnt be a serviceable piece)

Please let me know what you think
if you need a picture I can try to get one
Thanks