<BLOCKQUOTE class="ip-ubbcode-quote"><font size="-1">quote:</font><HR>Originally posted by J.T.H2:
Since we are on the subject...When I was programming my H2 the DTC code that I was getting was _B0229_. According to my guide it say that it is a _"HVAC Actuator Circuit"_. Again I do not know if this guide pertains to my H2. Is this the correct code description, and if it is, what the heck does it mean? Thanks <HR></BLOCKQUOTE>
DTC B0229, B0414, B0424, or B3770
Circuit Description
The following DTC's are for the HVAC door actuators:
B0229 is for the recirculation actuator.
B0414 is for the left air temperature actuator.
B0424 is for the right air temperature actuator.
B3770 is for the mode actuator.
The HVAC control module controls the HVAC door actuators to regulate the airflow through the HVAC system. Each actuator consists of a stepper motor, a logic circuit, and a potentiometer. The potentiometer inside the door actuator allows the module to monitor the current position of the actuator drive shaft. The module supplies a 5 volt source voltage to the potentiometer on the 5 volt reference circuit. The module supplies ground to the potentiometer through the low reference circuit. The HVAC control module monitors the voltage drop across the potentiometer on the door position signal circuit. When the actuator shaft rotates, the voltage on the door position signal circuit changes. The module converts the voltage value to a count value where 1 volt is approximately equal to 51 counts.
The HVAC control module calibrates the travel range of the HVAC door actuators when it is initially powered by the battery positive voltage circuit. During calibration, the module commands the actuators in each direction until door travel is stopped. The module stores the minimum door positions and the maximum door positions of each actuator into memory. The total travel range is calculated by subtracting the minimum door position from the maximum door position. The door actuators can be calibrated again with a scan tool.
Conditions for Running the DTC
Battery voltage is 8.7-16.5 volts.
The ignition is ON.
Conditions for Setting the DTC
The DTC sets when one of the following conditions are present:
The actual door position value for the actuator is less than 5 counts.
The actual door position value for the actuator is greater than 250 counts.
The actuator fails calibration because the calculated travel range value is too great or too small.
Action Taken When the DTC Sets
If the DTC sets because the actual door position value is out of range, the HVAC control module will command the actuator to a default position.
If the DTC sets because the actuator failed a calibration, the HVAC control module will attempt to calibrate the motor in the next transition from OFF to RUN mode.
Conditions for Clearing the DTC
The DTC will become history if the HVAC control module no longer detects the condition that set the DTC.
The history DTC will clear after 100 fault free ignition cycles.
The DTC can be cleared with a scan tool.
Diagnostic Aids
If the condition is not present refer to Testing for Intermittent and Poor Connections in Wiring Systems.
If the DTC sets following a calibration of the door actuator, inspect the door and the actuator for the following conditions:
A misaligned actuator
Broken linkages or binding linkages
A broken door or a binding door
An obstruction that prevents the door from operating within the full range of motion
Missing seals to the door
Poor connections at the harness connector of the door actuator
|