I just got home and crawled under My 05 and the drain is in diff. housing on bottom of course and the check hole is in the AAM stamped cover plate on rear of rear diff. Front has check and drain on drivers side and I could not even touch lube with pinky finger. I will top off in the morning. The rear is down below check quite a bit also will top off. This rig has been supposedly checked twice now and I find no leaks somebody is going to get an ear full Friday. Rear color looked normal but I have not run it hard as most.
Is that the same locations of the previous years? If not do I need to find a different cover plate than Phil's for rear. It appears the rear check is to right of center.
I'm wonderng if there is room for a larger cover as one on there now is all but touching a cross bar running center across the diff. that is between axle and sway bar levels. I wish my repair Cd's would get here. What is that little more like rectangular looking tube bar. It is closed in not angle iron type or I beam shape and assume it must have something to do with air ride?
thanks
TAZ
__________________
05 H2 SUV cus. paint, Magnuson SC 6/12lb boost, cowl hood scoop, 12" dash touchscreen, GM elec. fans, HPTuners.com tuning soft., Dynatech headers dual catback exhaust Jet Hot chrome front to back Flowmaster Super 40's, Diamo 8 Karat rims & 325X60-20" Toyo, 4 OEM Captain seats Katzkins leather, rear console computer inside running all AV/NAV etc., Infinity component system 3 amps Tsunami Caps, rear flip down 12" monitor, headrest monitors, overhead console boost, fuel pressure, & A/F ratio gauges
|