[iwillnc]

I've seen threads that have asked this question many times on here, it always no fail ends up where we get someone to buy a panel, and they say it's on it's way and that they will try it on and post pictures, then we mysteriously never hear from them again.

I'm sure it would fit just fine (as far as attaching to the door), simply because the doors never had any real change to the metalwork.

However you problem comes in when it comes to aligning with the dash, which almost surely will not happen (ie, the dash or the door pnael will have too much length and you won't be able to close the door), you also have to deal with the mess of the window defrost, which I don't believe is piped in the same way.
Then after that deal you have to deal with the wiring which will be completely different.

Even after this, it won't line up.

They are good looking door panels though, I'll give them that, also much better quality.

If you would like to get some presses and build and sell some door panels.... well you may get a couple buyers