Quote:
|
Originally Posted by Brazi
I have a few questions, if you can help me:
1. How large is the PCM and approximately how much does it weigh?
2. Would you reprogram this PCM differently or would you keep the original standard data?
3. Can an experienced mechanic/engineer can switch the PCM without many problems?
4. Is there anything else I should do?
|
Hi, Kelly from PCMforless here.
The PCM is small, perhaps 7"x7"x1" and weighs about 3lbs. It is something that can be switched out without needing the expertise of a mechanic.
However I am not sure that replacing the PCM would be the right thing, as this sounds like a problem with another control module, or braking system. In the PCM we are able to change things like timing, air/fuel, speed limiters, transmission issues, fans, etc etc but there are no areas to change or turn off codes for the braking system. Furthermore I would have to send you a new computer, which would require a CASE relearn. And since there are no dealerships near you, you would not be able to have that done.
Sorry but I do not think there is anything we can do to help you.