[Ed G.]

First you have to remove the hood louver. Do this by raising the hood and pop out the 3 clips under the hood panel that hold it in place. Most kits come with a template to mark the location of the holes you need to drill into the louver, if you don't have a template you will have to make your own. Make sure the holes (2 for each handle) are aligned and placed in the same location on each side. Drill the holes, reinstall the louver and attach each handle by lining up the holes you drilled with the bolt holes in the handles, insert the bolt through the hood and into the handle and tighten. It's a very easy install. Good Luck!