Quote:
|
Originally Posted by Gravel Maker
I think when we spoke this morning I thought you were talking whole vehicle skid plates. We are making them for some vehicles but not yet in full production. These Ubolt skids are pretty easy to make and they are on my list. If someone can verify for me that the leaf springs are GM width (2.5") and the axle housing is within the realm (2.75" - 3.25") they would fit fine. I will be making them both 3/8" thick, we don't play around. The cost would be $70 -80.....a pair.
Dan Fredrickson
www.ruffstuffspecialties.com
916.600.945
Your Fabrication Parts Source |
YEA!!!
I'll try to get under there with a tape measure this AM and maybe take some pics.
