[marin8703]

hey everyone. Im still trying to fix up the install of the viper 5900 SST on the H3. The only problem i have left is the door trigers.

They were origionally hooked up to four different wires at the BCM, with diodes and onto the viper brain. however that didnt work too well. if all doors are closed and you arm the alarm it will sound, but if a door is open it will ignore all door trigers until the alarm is disarmed and then armed again with the doors closed, and this would be on except that it doesnt notify of this and its supposed to, the problem seems to be that its not reading them like its supposed to.

so someone on the the12volt forum said that there are 2 wires in the drivers kick panel, black/white(-) for all but the drivers door, and grey(-) for the drivers door. i tried looking for these but i coulnt find them. can anyone confirm that they are there or somewhere around there?

or can someone suggest a better place if any or a better way of getting this to work? does anyone have a wiring diagram for the h3, for installing an alarm?

i need to get this done by new years so i would appreciate your help, thanks!