Re: engine light p0128 ?
Easy enough to install.
Its on the drivers side where the lower hose meets the engine ? Thermostat housing is straight the top one pass side is curved.
You have to remove skidplates and get to it from the bottom.
To get to the bolts you go through the wheel well.
for the upper bolt you have to jack the crossmember up a bit to raise the body.
I had a problem releasing the factory clamp,it was a bitch to do the one on the radiator so I replaced the thermostat housing side with a standard clamp.
Drained the radiator and put in 50/50 distilled water and anti freeze .
__________________
H3 gray adventure,brushguard,hood handles,sunroof,steps,crossbows,smokers package,window/sunroof visor,Airbrushed spare tire cover,mudflaps,K&N filter,SS Hummer insert,Hummer rubber mats,cargo rubber mat + shade,12 volt airhorn,eclipse nav/dvd/rear camera/mini remote,autostart,12 volt fridge,high beam garage remote,underhood air compressor, taillight bezels ,clinometer ,trailer brake and hitch.
|