[iwillnc]

Alright so my cooler is being installed, I'm going to try to finish tomorrow.

I'm installing mine slightly different, for one I kept looking at these pictures thinking WTF with how the driver side was connected, I was thinking Egan had used the original hole for the old cooler, finally I read he used a sheet metal screw, Doh.


Anyways, my cooler makes slight contact with my condensor if installed like in the pictures, the bottom of the cooler is too close .
What I did is bend the bottom supports, out at about 170 degrees, so instead of being behind the lower support, they can move further out over it allowing some room between the condensor.

Now I have to find some rubber isolators for the lower connection.