Quote:
Originally posted by f5fstop:
Not sure why everyone says you need air tools to install the rocker protectors. I have helped install two sets, and no air tools were needed, and the official time study performed by GM for warranty on these steps had to be performed using hand tools (GM requirement).
|
I can understand why GM wants it done by hand too. If you don't thread it first, and make sure it going in correctly, it has the potential of being crossthreaded and damaged. The area on the drivers side is so tight, it makes it very difficult.
TIP:
when using airtools, be sure to thread first, and do not over tighten. A light hand is best in this situation.