[LoJac963]

Yes everything is soldered in. The cluster bulbs have bases so you can remove the filament bulbs and bend the leads of the LED's around the bases or just skip the base and bend the leads and solder them in place.

Steering wheel controls you can wiggle out forward a little bit then you need to find something to reach behind to hit the release for the wire harness. Once each pack is out you'll see little tabs on the side. You'll have to take something to pry the backing off of each button pack to get to the guts. Once inside you'll see how easy it is to replace those also.

Overall replacing EVERY light in my rig was highly time consuming and required some ingenuity in placing the LED's but it's not impossible by any means. With basic soldering skills anyone could do it.