Quote:
Originally Posted by Easy Ed
Hoping for the best VegasGuy
Ed
|
Thanks, Ed. I would not have attempted this project without your instructions.
After 8 hours of squirting Liquid Wrench and then switching to WD-40 I finally got the motor to break free. I tested it with a 9-volt battery and it worked like a charm.
The only question I have is regarding the two fly-speck magnets. I removed them for safe keeping while working on the motor. Did you pay attention to the magnetic polarity when you put them back into their little holes? (I did.) I hope the magnets are strong enough on their own to keep them from flying out of the holes when the motor spins up. If they fly out, I will never find them again if they go into the gear box.