Re: 2008 no start
Thanks for that guys, i've found the problem, i had a think about it last night and thought that no communication with the Tech II means the FPCM is not getting power or a ground, so i traced the wire from the fuse block under the hood and did a continuity test, i got down to the last inch of wire going into the FPCM module and there was the problem, the wire had separated from the socket inside the plug, even though the terminal was still inside the plug, reattached it and its all a go now, thanks for all your input.
PS here is a pic of a RHD H2 it took 6 months to finish
Last edited by aussieh2 : 11-15-2008 at 01:57 AM.
|