I'd figure to post in 2 spots to get a few guys perspective on thhe install.
Just finished reading up on installs. I'm a Kenwood man nyself but the basics apply to any aftermarket radio. I have a DDX7019 I picked up used to replace our Monsoon set up in the 07 H3. I've also found eventhough the manual says to use the RCA inputs from the radio to the harness - this makes a loud speaker pop everytime you turn the unit off. By using the regular speaker outputs this is eliminated.
A few questions:
1. I bought a Pac-Audio wire harness to keep the "beep/tone" Is it really necessary? At $120 seems steep compared to the $5 harnesses i've bougth for many installs I've done. (
http://www.pac-audio.com/instructions/c2r-gm24.pdf)
2. Is it me or does the Sub seem to sound lower? The OEM sounds like it had more punch from the sub. I know the front/rear wire which go to the amp are aldo supposed ot power the sub but just seems lower.
__________________