Thread: 2008 no start
View Single Post
  #2  
Old 11-14-2008, 03:33 PM
Planohummer Planohummer is offline
Hummer Veteran
 
Join Date: Aug 2005
Posts: 184
Planohummer is an unknown quantity at this point
Default Re: 2008 no start

check two areas:
1)behind fuse block on driver end of dash, connector at top right that's not clicked into place
2)there are two metal snap clips holding trans harness to side of trans. they're on the metal shielded cable area. make sure neither is cutting into the harness.
The u0109 indicates no communication between PCM and FPCM, not necessarily a fault in either module.
Reply With Quote