<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by GMPartsGuy:
<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by Operator24:
Another question to throw out there...
I'm trying to figure out if you'd have to change the locker out for one that accepts a higher ratio gear OR if you're currently forced to get a set of "thick gears" made (maybe some already exist?) to regear an H3.
Is the rear locker in the 10 bolt rear axle an EATON model of the elocker? I could look up the model and see where the carrier gear break is and figure this out if I knew the model rear locker thats in the H3s? </div></BLOCKQUOTE>
The differential is a newer variant of the Eaton 10 bolt. It doesn't use legacy gear dimensions. </div></BLOCKQUOTE>
So, what about adding a front E locker?
__________________
TAIL RATED!
|