New Toys for my H2

[Gary]

SJ,

Thanks. I like the PIAA 520's I used the same wiring from my factory brush guard lights, so the swithch in the interior is factory. The lights fit perfectly. I have had problems with rust on the housing and two of the four screws that hold the back plate on broke off. So I will have to do some mods to the housing unit.

The 37" MTR's I just put on yesterday. The spare is also a 37" MTR and just fits in the back. LOL. I also put in H2 lift lips which cover all of the insides of the wheel wells with rubber to avoid mud, etc from getting into the engine compartment. These only ran about $50.00 to get and will save me hours of time not having to clean the wheel wells that are exposed showing the frame and inside of the engine compartment.

I haven't taken it off roading yet with the new MTR's. I will report back to you about any problems with clearance. I do have the air suspension on my H2.

Respectfully yours,


Gary
Finlayson, MN

My H2 HUMMER

FinancingYourHome.com