AC Update: ;(

[OrangeCrush]

Well, things aren't as they seem. When I got my ac redone, I thought it was great. The problem was it was only in the low 80's with low humidity for those few days.

Now that it's back in the high 90's with high humidity, my AC sucks. I took it back to my tech friend at a dealership and the low pressure went back up. He thought perhaps at some point too much oil had been installed so he drained it.

After checking everything out, they end up replacing the compressor, accumulator AND clutch fan and though it's ice cold while moving, it still sucks at an idle.

I'll probably have to add an aftermarket fan to keep the condenser cool... all this from checking out an orifice.

Guess we'll see where it goes from here...

Mark

[h2co-pilot]

I think you have learned not to mess with any more orifices.

Sorry Mark, that sux. Keep us updated.

[H2 Ranger]

OC,
If it were me I would check the Expansion Valve or recheck the Orfice (did you reverse it?) The real question should be how is the High pressure getting on the low pressure side of the system. What was the pressure of the low side and High Side? There should be no reason to add a fan just for the AC otherwise a lot of owners would need to do the same. Let us know what you get done. AC seems to be a subject that we always say, ok whatever you want to replace.

[PARAGON]

Originally Posted by OrangeCrush

Well, things aren't as they seem. When I got my ac redone, I thought it was great. The problem was it was only in the low 80's with low humidity for those few days.

Now that it's back in the high 90's with high humidity, my AC sucks. I took it back to my tech friend at a dealership and the low pressure went back up. He thought perhaps at some point too much oil had been installed so he drained it.

After checking everything out, they end up replacing the compressor, accumulator AND clutch fan and though it's ice cold while moving, it still sucks at an idle.

I'll probably have to add an aftermarket fan to keep the condenser cool... all this from checking out an orifice.

Guess we'll see where it goes from here...

Mark

Mark,

the fan won't work. trust me, I know things.

I am guessing you idle at or just below 600. It's too f'ing low for the compressor. What ever programmer (I know the Diablosport allows you to do it) will allow you to change the idle RPM while A/C ON, it's worth getting.

If I can get Diablosport to fix my programmer I am going to adjust my idle speed back up.

Paid a lot more attention to it just recently because on Thursday in the middle of nowhereville 100-degree Texas, one of my A/C lines popped. The compressor had let go and dumped trash into the system. So I paid $1300 to get it bandaided back together with a manufactured hose, Chevy dealership compressor but since the drier on the H2 is unique, I couldn't get it replaced and I might still eat the new stuff. So, I don't have a warranty on the new stuff just so I could get some A/c gong for the K-Rocks event.

Anyway, we were going over it after the repair and with my programmer hooked up and monitoring the RPM and other diagnostics, the A/C blows cold at about 650 RPM as the lowest and it doesn't seem to pull any more on the truck while in drive than before. I can hold the pedal just right and have the A/C blow cold while stopped at a light.

[dochummer]

I had my compressor replaced back in october of last year, right before the warranty ran out. We've had some 100 degree days the last few days, and It seems my AC isn't running as well. It does work better when going down the highway, but in the city...it takes forever for it to cool down. I've also noticed, that it works better if I don't set it at 60, but instead at 70 or even 80 degrees... Could be all in my head... The local dealership says it's normal.....

[PARAGON]

Originally Posted by dochummer

I had my compressor replaced back in october of last year, right before the warranty ran out. We've had some 100 degree days the last few days, and It seems my AC isn't running as well. It does work better when going down the highway, but in the city...it takes forever for it to cool down. I've also noticed, that it works better if I don't set it at 60, but instead at 70 or even 80 degrees... Could be all in my head... The local dealership says it's normal.....

RPMS

[OrangeCrush]

Well this last weekend since I was at the beach stuck in 100 degree weather and at a standstill in traffic for over AN HOUR gave me a good chance to see how it's working.

My tech replaced everything again... another new compressor, etc, etc.
With the truck just idling, the temp gets down to 46'ish Going down the road or stepping on the gas to bring the idle up will bring the temp down to 42-43. That's ICE COLD.

However, getting stuck in traffic for an hour or so, you can feel the temp difference. I still want to try the fan trick.

Paragon, why won't the fan idea work? Even GM's on their Yukons had a Service Bulletin to add a supplemental fan when the vehicle sits at a light. Any air flowing over the condensor should help. I know the H2 doesn't have the greatest mounting place but isn't there a way to make some air go over the condensor?

Thanks,

Mark

[PARAGON]

Originally Posted by OrangeCrush

Well this last weekend since I was at the beach stuck in 100 degree weather and at a standstill in traffic for over AN HOUR gave me a good chance to see how it's working.

My tech replaced everything again... another new compressor, etc, etc.
With the truck just idling, the temp gets down to 46'ish Going down the road or stepping on the gas to bring the idle up will bring the temp down to 42-43. That's ICE COLD.

However, getting stuck in traffic for an hour or so, you can feel the temp difference. I still want to try the fan trick.

Paragon, why won't the fan idea work? Even GM's on their Yukons had a Service Bulletin to add a supplemental fan when the vehicle sits at a light. Any air flowing over the condensor should help. I know the H2 doesn't have the greatest mounting place but isn't there a way to make some air go over the condensor?

Thanks,

Mark

That's what the guy at the fixit place in Texas said. Something about the RPMs of the truck being too low and building head pressure and the compressor not operating at the right efficiency or something.

I don't know if it will work or not, personally. He said that many 6.0L are idling too low for the compressors and I kinda half-assed believe him because I can increase the RPMs while stopped at a light and the A/C gets cooler. Other than that, I dunno.