OEM Hummer Off-road lights (roof rack) install question

[H2Finally]

PLEASE HELP...

Off ebay, got 4 oem off-road roof lights with wiring harnesses (cut short) and screw knobs. No bar.

Questions:

1. Can the lights go on a standard roof rack bar?

2. What kind of nuts hold the screw knobs down? (Didn't come with any)

3. Do I drill holes through the rubber piece on top (middle) of bar for the screw knobs? Or do I just remove the entire rubber piece?

4. How are the wiring held in place? Hidden inside rack, or just tied at bottom?

5. Anyone figured how to flip/fold the lights down when not in use (for help in clearance issue)?

MUCH OBLIGED!!

[H2Finally]

PLEASE HELP...

Off ebay, got 4 oem off-road roof lights with wiring harnesses (cut short) and screw knobs. No bar.

Questions:

1. Can the lights go on a standard roof rack bar?

2. What kind of nuts hold the screw knobs down? (Didn't come with any)

3. Do I drill holes through the rubber piece on top (middle) of bar for the screw knobs? Or do I just remove the entire rubber piece?

4. How are the wiring held in place? Hidden inside rack, or just tied at bottom?

5. Anyone figured how to flip/fold the lights down when not in use (for help in clearance issue)?

MUCH OBLIGED!!

[H2Finally]

Thanks Phil, o Hummer Lighting Guru!!

Another question: I have taken the trouble of installing additional switches inside before, so I have extra relays inside the engine compartment. Any suggestion which route I should go to connect wires from roof to engine compartment?

THANKS AGAIN!!!

Anyone with nut info?

[H2Finally]

PLEASE HELP...

Off ebay, got 4 oem off-road roof lights with wiring harnesses (cut short) and screw knobs. No bar.

Questions:

1. Can the lights go on a standard roof rack bar?

2. What kind of nuts hold the screw knobs down? (Didn't come with any)

3. Do I drill holes through the rubber piece on top (middle) of bar for the screw knobs? Or do I just remove the entire rubber piece?

4. How are the wiring held in place? Hidden inside rack, or just tied at bottom?

5. Anyone figured how to flip/fold the lights down when not in use (for help in clearance issue)?

MUCH OBLIGED!!

[H2Finally]

Phil, since I've placed the extra relays outside, I am really reluctant to have to run the wires inside the cabin just to get it outside to the engine bay again (though the earlier thread where you have pic & instructions on running the wire to the inside is in my fav folder archive! ).

Any other ideas? Much appreciated!