Door panel removal

[f5fstop]

Remove window switches; push into the switch at the rear and pry up at the rear, lift and disconnect connector(s). Use a small screwdriver, and most likely the back spring clip will fall, when you get the door panel off, you can replace the clip, it just slides into the switch.
Remove the round cover behind the door handle and remove the torque head screw.
Remove the large cover running the top to bottom length of the door pull handle, and remove the two screws. (Use a small thin screwdriver on both of these covers and just pry, then pull off.)
Then, at the bottom of the door, grab hold and pull, there are about six to eight reusable plastic retainers.
When all retainers are free from the door frame, lift the door slightly off the top of the door where it slides into the window slot, then look behind and unclip the two cable; one for the door handle, one for the lock switch.
Install in reverse order, and don't forget to reattach the cables.