New Problem Discovered....New discussion to the forum

FishnMan · #1 01-30-2006, 06:00 PM

OK, here's the problem. As you see in the picture (not my H3), the circled area shows where the roof moldings meet. They should be flush against each other, right? Well on mine, there is about a quarter inch or more space between the moldings on both the passenger and drivers side. Not only that, the trim/molding underneath where they are supposed to meet is severly cracked/damaged. Has anyone else noticed this problem? I have warranty service visit scheduled next week have it looked at. My guess is it has been @ 40 below zero the last 2 weeks and I have to slam the doors to close them (Bulletin #05-08-64-002A Door Latch Freezing In Cold Temperatures). Then again, the piece that's cracked doesn't appear to be impacted when slamming the doors, so I don't know! I just noticed it today at work so I cant get an actual picture until tonight. oh, and I don't have the marker lights, so is there supposed to be gap there? Eitherway, the underneath shouldnt be cracked open! Any thoughts or similar problems out there?

thanks all

fourfourto · #2 02-03-2006, 02:05 PM

I didn't here from dealer about rail comming in yet.They ordered it last oil change about 4-6 weeks ago.Hopefully its in by next oil change about 4 to 6 weeks away.
Below is pic of crack on passanger side.

Mike of Iowa · #3 02-02-2006, 01:55 AM

Mine was cracked as well. I went to the dealer and found 5 more with the same problem. GM called me yesterday to ask how I like the H3 and they are aware of the assembly problem.

Mike

fourfourto · #4 01-30-2006, 07:22 PM

Mine has small gap I did bring it in at last service because right side wasnt clipped properly ,that fixed it also the left side had crack in roof plastic they ordered it and Im still waiting for it to come in.They are covering it under warranty no hassle.I will have them install new plastic at next oil change Ill have them look at the rear washerpump at that time that is on recall probobly get tires rotated and leave the truck for the day.Maybee they will give me a h2 loaner

BABHUMV · #5 01-30-2006, 11:57 PM

Mine is at the dealer today and that is one of the things I pointed out to them. There is a gap and the piece is cracked underneath. They said warranty. Better be!

I am getting the DVD headrests and marker lights installed. Dealer screwed schedule up

so I won't get it back for a three days

. Gave me a Caddy to drive, so not too upset. Just not my Hummer though.

FJD · #6 02-03-2006, 05:19 PM

**** me, I got it too !!!!

HummBebe · #7 01-30-2006, 06:15 PM

Mine are not flush, and if you have had Marker lights and or Roof racks installed, it could have just been put back together a little out of alignment. No biggy.

There is a fix, but it will take a little disassembly, are you wanting to do this? I can help.

BABHUMV · #8 02-03-2006, 05:38 PM

<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by Webb70:
<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by BABHUMV:
Mine is at the dealer today and that is one of the things I pointed out to them. There is a gap and the piece is cracked underneath. They said warranty. Better be!

I am getting the DVD headrests and marker lights installed. Dealer screwed schedule up

so I won't get it back for a three days

. Gave me a Caddy to drive, so not too upset. Just not my Hummer though. </div></BLOCKQUOTE>

How much for the DVD headrests installed if you don't mind me asking? I would like to get a set. </div></BLOCKQUOTE>

OTD was $607.00 $499. plus tax on $1499. I bought my H3 11/18, so there was a valid rebate available and the dealer honored it. They are cool and worth it.

usetosellhummer · #9 02-02-2006, 12:22 PM

Welcome to Hummer fit and finish. Try to explain the H1 body

DCCP · #10 02-02-2006, 05:12 PM

got the same problem as well don't know how it happened but this should be a recall.

hdfatboy · #11 02-08-2006, 12:38 AM

No adjusting the switch, the dealer replaced with a new one. When I applied an upward pressure on the steering wheel the creaking went away. It part of the tilt assembly.

<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by UNOMYFLO:
hdfatboy

where is the column switch?

I have the creaking also.

where exactly is it? what switch is it?

Will tightening it stop the creaking? </div></BLOCKQUOTE>

FishnMan · #12 01-30-2006, 06:00 PM

OK, here's the problem. As you see in the picture (not my H3), the circled area shows where the roof moldings meet. They should be flush against each other, right? Well on mine, there is about a quarter inch or more space between the moldings on both the passenger and drivers side. Not only that, the trim/molding underneath where they are supposed to meet is severly cracked/damaged. Has anyone else noticed this problem? I have warranty service visit scheduled next week have it looked at. My guess is it has been @ 40 below zero the last 2 weeks and I have to slam the doors to close them (Bulletin #05-08-64-002A Door Latch Freezing In Cold Temperatures). Then again, the piece that's cracked doesn't appear to be impacted when slamming the doors, so I don't know! I just noticed it today at work so I cant get an actual picture until tonight. oh, and I don't have the marker lights, so is there supposed to be gap there? Eitherway, the underneath shouldnt be cracked open! Any thoughts or similar problems out there?

thanks all

thedieter · #13 02-01-2006, 02:44 AM

Our Poppy (as in California Poppy) has a gap in that location, which doesn't concern us but there is a small crack about 1/4" long on one side.

On aircraft we drill a small hole at the end of the crack to stop it from progressing and I am considering doing that to this crack. I wonder if that would prevent warrantee repair at a later time.

Best regards, Happy Jack

UNOMYFLO · #14 02-02-2006, 07:46 PM

hdfatboy

where is the column switch?

I have the creaking also.

where exactly is it? what switch is it?

Will tightening it stop the creaking?

partsguy · #15 01-30-2006, 06:17 PM

As far as the gap it is what it is.But the cracked roof rail is a problem.It is an installation fopa.
They are working on how to install it so the rail will not crack.The parts are not avaible
untill a fix is found.

BforBRAD · #16 02-09-2006, 03:55 PM

I have the crack also(about an 1 1/2")but just on the drivers side.Has anyone else had water on the door sill(small amount)because of the crack? I'll have the dealer check it when I bring it in for my first service.

FishnMan · #17 01-30-2006, 08:03 PM

Everyone....
Thanks as usual for all the feedback.

HummBebe: Thanks for the assistance, but I will probobly just have the dealer deal with it. Oh, and I don't have maker lights OR roof rails.

HummBebe · #18 02-02-2006, 01:22 AM

Can someone post an actual pic?????

Webb70 · #19 01-31-2006, 08:48 PM

<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by BABHUMV:
Mine is at the dealer today and that is one of the things I pointed out to them. There is a gap and the piece is cracked underneath. They said warranty. Better be!

I am getting the DVD headrests and marker lights installed. Dealer screwed schedule up

so I won't get it back for a three days

. Gave me a Caddy to drive, so not too upset. Just not my Hummer though. </div></BLOCKQUOTE>

How much for the DVD headrests installed if you don't mind me asking? I would like to get a set.

NewHummerGuy · #20 01-31-2006, 10:57 AM

Mine as well have cracked in a spot. They told me once a solution is found they will fix.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode