This is becuae the angle of the stem opening is at a different angle as the factory one
This is becuae the angle of the stem opening is at a different angle as the factory one
Some important things to remember. Make sure to torque the nut to 7 N.m (62 in-lbs). The cap is aluminum, the step is nickel plated for a reason, so if replacing the cap. make sure to use an aluminum cap. The cap, along with the stem are used as the antenna to signal the system
To prevent any TPM messages, try and keep the same sensor at the same corner of the vehicle. The system has an auto re-learn, but you will have a message displayed until the system re-learns the sensor positions. Keeping them in the same location prevents these messages.
(ME TOO)
Thread Tools
Search this Thread
Display Modes
Posting Rules