Slantback kit interest?

[HUMMERcustoms.com/TAZ]

I have not responded but, Beastmster has actually been making the points that i have noticed while I had been begining research on this last few days. There is almost now way to make the cover water tight. I would say impossible but, that does not exsist in My thought procees. But, it can be made weather resistant and lockable. The problem is if it is installed at Our shop or is it shipped to the buyer and He has to do a good enough job to have a water tight fit. I know Our guys well enough that if it was installed by them it would most likely be water tight. Cost would fall more into Dragon's area as He and the shop Boss are skilled in using many materials. It just looks like it would run around the $3000 range or little more. You would have to keep in mind it is not just buying some material and slapping it on the rig. It has to be made a prototype first but depending on the material finally decided on it would be hand made evey time, or molded and just a pour each time, and last it could be made from a light metal that can be farmed out and tooling to stamp it out in as few parts as possile and then assembled. If You price the plain hard flat caps they run upwards of $2500. This kit will be much harder to do. So it would lean into the higher side of most everyone's estimate of $2000 up. If it had to be done in glass then it is still hand made with molds. It would take a major corp. to pick it up and automate it to get it even down to the $2000 range.

TAZ