wheelin today and a couple of issues

[timgco]

Went out wheelin today with the CO group. Had a blast. The H3 did very well with two exceptions.

1) I got up to around 13,000 ft and the truck started sputtering and I had almost no power. Foot to the floor in 4LO locked and wouldn't move but 1 mph. It did this for a couple hundred yards. I shut the truck off, and the problem stopped, but the check engine light was still on. I cycled the engine on and off a few more times and still no problem and the check engine light out.

egine power reduce, stabilitrack off, stabilitrack failed. It flashed these over and over durring those few hundred yards, had the little engine light on, and than it went back to stabilitrack off. no more issues.

2) The dumbass that changed are oil last didn't put the bolts back into the skid tight, so we lost one and the other was barely hanging in there. Also missing were the two bolts to hold the UC protection through the skid plate. Anyone know what size bolts I need to get for the back of the first skid plate that has the H3 logo on it (need two) and also for where the next shield goes where the UCP protection mounts to (also need two)

Other than that, it was a lot fun today!!!!!